company news about how to install concealed hinges

Installing concealed hinges, also known as European hinges or cup hinges, typically involves several steps. Here’s a general guide on how to install them:

Tools and Materials Needed:

• Concealed hinges (with cups)
• Drill
• Drill bits (for pilot holes and counterbores)
• Chisel
• Hammer
• Screwdriver or drill with screwdriver bit
• Measuring tape
• Pencil
• Wood boring bit (optional, for pre-drilling the cup holes)
• Clamps (optional, for holding the door in place)

Instructions:

1. Prepare the Door and Frame:

   • Measure and mark the positions for the hinges on both the door and the door frame. The typical installation is 3-1/2" from the top and bottom of the door, but this can vary depending on the door size and design.
   • Ensure that the marks on the door and frame are aligned when the door is closed.

2. Drill Pilot Holes:

   • Drill pilot holes for the hinge screws. The size of the drill bit will depend on the size of the screws that come with the hinges.

3. Drill Counterbores (Optional):

   • If you want the screw heads to be flush with the surface, drill counterbores that are slightly larger than the diameter of the screw heads.

4. Cut the Hinge Cups:

   • Using a chisel or a wood boring bit, cut out the hinge cups in the door edge and door frame where you made your marks. The cups should be deep enough to fully seat the hinge cups.

5. Test Fit the Hinges:

   • Place the hinge cups into the holes you’ve cut and ensure they fit snugly. Make any adjustments as necessary.

6. Attach the Hinges:

   • Insert the hinge leaf into the hinge cup on the door.
   • Secure the hinge to the door using the provided screws, tightening them into the pilot holes you drilled earlier.
   • Repeat the process for the frame side of the hinge.

7. Mount the Door:

   • With the hinges attached to both the door and the frame, position the door in the frame.
   • Make sure the door is plumb and the gaps around it are even.
   • Insert the hinge pins into the hinges to secure the door in place.

8. Adjust and Fine-Tune:

   • Open and close the door to check for proper alignment and operation.
   • Adjust the hinges as needed to ensure the door operates smoothly and the gaps are consistent.

Remember that the exact steps may vary depending on the specific type of concealed hinge you are installing. Always refer to the manufacturer’s instructions for the most accurate and detailed guidance.